DEPARTMENTS
BEST SELLERS

Milliput

Ramages DIY | DIY products | Adhesives and fillers |  Milliput

Milliput

Milliput

Price: 3.59

Quantity:

The Milliput Standard is a very versatile model filler and adhesive. Milliputs drying time depends on the temperature, but at room temperature it is hard in 3 to 4 hours. If you speed the process by applying heat the hardening time can be reduced to just a few minutes. Milliput will set under water and is heat resistant up to 130C

It is a versatile putty which adheres to and will seal or bond metals, wood, plastics, glass, tile brick, cement etc. Milliput can be used for mould making and can be cast.

After Milliput is set hard, it will continue to cure and is fully dry in around 8 hours. After this it can be machined, drilled, tapped, turned, filed, sawn, sandpapered and painted. Milliput can be sandpapered and painted immediately after it has set (it is advisable to wear eye protection during this process).

Milliput is an excellent adhesive and will bond any of the following to itself or to any of the others - wood, brick, cement, metals, concrete, plastics, glass etc, but note that Milliput is not intended as a thin layer adhesive and should not be used where a paste, mucilage or thin glue is indicated.


Go Back

Ramages DIY | DIY products | Adhesives and fillers |  Milliput